With newly introduced sp2D/3D View Module and powered by the advanced and flexible graphical interface of new spSection Module for creating and modifying irregular sections, spColumn v6.50 is widely used for design and investigation of columns, shear walls, bridge piers as well as typical framing elements in buildings and other structures. Equipped with latest American (ACI 318-14) and Canadian (CSA A23.3-14) Concrete codes, spColumn is developed to design and investigate any reinforced concrete sections subject to combined axial and flexural loads. Formerly pcaColumn, PCACOL, and IrrCOL, spColumn investigates sections that are impossible to find on design charts or to do by hand. The section can be rectangular, round or irregular, with any reinforcement layout or pattern. The program offers investigation of irregularly shaped, reinforced concrete column sections that may contain openings or boundary elements. Top selling worldwide, spColumn provides a full featured 3D visualization of the nominal and factored failure surface. Import/export of DXF files, nominal interaction diagrams, and display of capacities at your load point are just a few of the rich program features.
spColumn comes with new sp2D/3DView module. Preview the video below.
The analysis of the reinforced concrete section performed by spColumn conforms to the provisions of the Strength Design Method (CSA A23.3) and Unified Design Provisions (ACI 318). All conditions of strength satisfy the applicable conditions of equilibrium and strain compatibility.
For the ACI codes, the nominal (unreduced) capacity of the section is first computed. Then, the nominal capacity is reduced to the design capacity using the strength reduction factor, Φ.
spColumn computes the interaction diagram (uniaxial runs) or the three-dimensional failure surface (biaxial runs) of the input section. The values of maximum compressive axial load capacity and maximum tensile load capacity are computed. These two values set the range within which the moment capacities are computed for a predetermined number of axial load values.
Based on the specified minimum, maximum and increment specified for the section and the reinforcing bars, the program selects the smallest section with the least amount of reinforcement for which the load-moment capacity exceeds the applied loads. Depending on the design criteria the user selects, the least amount of reinforcement the program searches for means either the smallest number of bars or the smallest steel area.
The program starts the design by trying the smallest section (minimum dimensions) and the least amount of reinforcing bars. The program verifies that the ratio of provided reinforcement is always within the specified minimum and maximum ratios. Furthermore, unless otherwise specified by the user, the bar spacing is always kept greater than or equal to the larger of 1.5 times the bar diameter or 1.5 in. [40 mm] for ACI and 1.4 times the bar diameter or 1.2 in [30 mm] for CSA.
The program can compute section capacity in one of the two avaiable methods, naemly, Moment-Capacity Method and Critical-Capacity Method.
Moement-Capacity Method calculates the section capacity as the ratio of moment demand, Mu to moment capacity, ΦMn. When a unique value of ΦMn cannot be calculated for a given load point, this method gives the capacity ratio as "> 1" or "< 1" depending on the location of the point.
Critical-Capacity Method calculates the section capacity based on the closest distance to a load-point from the normalized interaction diagram. More information on normalized interaction diagram and calculation of the closest distance, d, can be found in spColumn Manual
spColumn imports section shape and reinforcement from DXF files to overcome complex geometries and reinforcement configurations.
CDR is used to provide information about the status of all the factored applied loads with respect to the section capacity (the ratio of section flexural capacity to required capacity for a certain axial load).
Additional 20% discount available for multi-product bundle purchase spMats, spBeam, spColumn, spSlab, spWall, spFrame (formerly pcaMats, pcaBeam, pcaColumn, pcaSlab, pcaWall, pcaFrame). Email us at info@StructurePoint.org for more information on pricing and licensing.